Skip to content

Patient Resource

Next Health Peptide Guide

Your step-by-step hub for safe, effective, and stress-free peptide use at home.

Peptide Pen Guide

Getting Started: Checklist of What You'll Receive

  • Peptide pen
  • Pre-filled cartridge with the peptide
  • Needle tips
  • Alcohol pads

Your Medical Provider will send your prescribed dose by email. Turn the dial on the pen to the number of units prescribed before injecting.

Peptide Vial Guide

Checklist of What You'll Receive

  • Vial of Lyophilized (Freeze-Dried) Peptide
  • Bacteriostatic Water
  • Syringes (100 units / 1cc / 5/16” / 31 gauge)

What You'll Need to Have Ready at Home

  • Clean counter
  • Soap & water
  • Alcohol swabs
  • Sharps container or needle clipper

How To Mix Your Peptides

Please note: you will receive either reconstitution syringes or insulin syringes to complete the reconstitution steps.

  1. 1Disinfect the tops of both vials (peptide & bacteriostatic water) with alcohol swabs.
  2. 2Draw air into the syringe equal to the amount of bacteriostatic water you'll use. Inject this air into the water vial (this helps avoid pressure build-up).
  3. 3Withdraw the prescribed amount of bacteriostatic water.
  4. 4Inject bacteriostatic water slowly into the peptide vial, letting it run down the inside of the vial — avoid shaking.
  5. 5Gently swirl the vial (do not shake) until the powder fully dissolves.
  6. 6Label the vial with the date. Reconstituted peptides are stable up to 90 days.

Storage Instructions

  • Store reconstituted peptides in the refrigerator.
  • Keep reconstituted peptides away from direct light and do not freeze.
  • Ensure the vial is upright and securely sealed.
  • Shelf life: most peptides are stable for up to 90 days after reconstitution — check your Medical Provider's guidance.

Dosage & Injection Timing

  • Dosage and injection timing may vary based on individual needs and treatment goals.
  • Follow your Medical Provider's recommendations to ensure safe and effective use.

How to Inject Peptides

Injection Steps

  1. 1Choose your injection site (usually the belly fat around the navel or outer thigh).
  2. 2Clean the injection site area and vial top with alcohol swabs.
  3. 3Draw your dose carefully using the syringe (refer to instructed dosage from your Medical Provider).
  4. 4Pinch the skin, insert the needle at a 90° angle, and inject slowly.
  5. 5Dispose of the needle safely in your sharps container.

Safe Disposal

Sharps Container Use

  • Always place used needles directly into an FDA-cleared sharps disposal container — never in the trash or recycling.
  • These containers are puncture-resistant and leak-proof with a secure lid.
  • Available at pharmacies, medical supply stores, or online.

Why It Matters

Improper disposal can injure others and spread serious infections like HBV, HCV, and HIV.

Disposing Full Containers

Do not throw full sharps containers in household trash.

Disposal methods vary by location \u2014 find approved drop-off or mail-back programs near you at SafeNeedleDisposal.org.

For full safety guidelines, visit the FDA Sharps Safety page.

Troubleshooting & FAQ

What if I bent the needle?
Do not use a bent or damaged needle. Dispose of it safely in a sharps container and use a new syringe.
What if I feel pain, swelling, or redness?
Mild irritation at the injection site can be normal. However, if symptoms worsen or persist, contact your Medical Provider.
Can I travel with peptides?
Yes. Use a travel-friendly insulin cooler to keep your peptides cool during travel. We can provide a travel letter upon request to assist with security or customs checks.
What if I miss a dose?
Do not double up. Simply take your next scheduled dose as usual.
How do I reorder?
Call or text the main Next Health line to schedule an appointment with a Medical Provider: (310) 295-2075.

Get Support

For more details, prescription refills, or to schedule an appointment with a Medical Provider, please call or text (310) 295-2075.